 |
 |
 |
 |
 |
 |
 |
 |
| “We have been filming for over 10 years, but recently started using the VideoMic Pro, and Stereo VideoMic Pro. While filming in remote places and tight spots, it's very difficult to use booms, and recorders are not that dependable when on the move. Our videos now have the look and feel that we have been attempting to get for so many years.” |
 |
The NT55 utilises the 1/2" gold sputtered true condenser transducer used in the internationally renowned RØDE NT5. The NT55 is a low-noise, balanced output microphone, exhibiting a wide dynamic range and full frequency response.
The NT55 circuit incorporates a three position variable PAD with 0dB, -10dB or 20dB attenuation, and a three position variable high-pass filter that enables you to step from a flat response to 75 or 150 Hz high pass filter.
The NT55 comes with two different condenser microphone heads to provide a wide variety of polar patterns. The NT55 is complemented with a diverse range of accessories to better facilitate positioning and attachment.
| Tweet |
|
|
Seen someone using the NT55 that we don't know about? Tell us here!
| Acoustic Principle | Pressure Gradient |
| Active Electronics | JFET impedance converter with bipolar output buffer |
| Capsule | 0.50" |
| Polar Pattern |   |
| Address Type | End |
| Frequency Range | 20Hz - 20kHz |
| Output Impedance | 100Ω |
| Maximum SPL | 136dB SPL (@ 1kHz, 1% THD into 1KΩ load) |
| Maximum Output Level | 8.0dBu (@ 1kHz, 1% THD into 1KΩ load) |
| Sensitivity | -38.0dB re 1 Volt/Pascal (12.60mV @ 94 dB SPL) +/- 2 dB @ 1kHz |
| Equivalent Noise Level (A-weighted) | 15dB-A |
| Power Options |  |
| Weight | 110.00gm |
| Dimensions | 145.00mmH x 20.00mmW x 20.00mmD |
| Output |  |
